PCR 介绍

1,Introduction

More than 15 years after its initial description, the polymerase chain reaction (PCR) has become a standard molecular biology tool and is the most widely used method of nucleic acid amplification. The procedure is based on the ability of DNA polymerase to copy a strand of DNA by elongation of a complementary oligonucleotide primer. As use of PCR has increased, scientists have improved upon the initial PCR method with valuable modifications. Today PCR is performed in multiple formats including single tubes and multi-well plates. Fairly precise quantitative techniques have been developed from the basic technology allowing the amplification process to be monitored. The PCR technique has become an important basis for an expanding number of molecular diagnostics applications.

2,The Basics

As originally described, PCR exploits the DNA replication mechanisms of the cell. Using a thermostable DNA polymerase, two oligonucleotide primers (usually between 18 and 28 nucleotides in length) and deoxynucleotide triphosphates (dNTPs), a specific DNA sequence is amplified exponentially. The primers flank the region of interest and are complementary to opposite strands of the template DNA (see Figure 1). PCR involves repeated replication of template DNA via a series of cycles. Each cycle consists of three stages:

• Template denaturation• Primer annealing• Primer extension

During denaturation, the strands of the DNA template are separated at an elevated temperature. When using Taq DNA polymerase,this temperature is typically 94-95°C and lasts 45 seconds to a few minutes.

In the second stage, annealing, the primers are annealed to the template. Temperature is critical to the proper attachment of the primer to the single-stranded DNA template. A typical annealing temperature is 3-5°C lower than the calculated melting temperature of the primers.

During the final stage, primer extension, the thermostable DNA polymerase carries out DNA synthesis. This part of the reaction is carried out at or near the optimal temperature required by the thermostable DNA polymerase. When using Taq DNA polymerase this temperature is 72-78°C and lasts about 1 minute for every 1000 bp of product. Depending upon the annealing temperature of the primers, the primer annealing and extension stages can be combined into one step, usually carried out at 72°C.

These three stages comprise one cycle. The number of cycles of PCR required for amplification depends upon the number of copies of DNA template present at the beginning of the reaction and the efficiency of the primer extension and amplification. As each cycle is completed there is an exponential accumulation of a specific fragment whoseends are determined by the 5'ends of the primers.

PCR can proceed until one of the essential components becomes limiting.

The essential components of PCR are:

(1) a thermostable DNA polymerase

(2) a pair of synthetic primer

(3) deoxynucleotide triphosphates (dNTPs

(4) reaction buffer to maintain pH (typically containing Tris and KCl)

(5) divalent cations (most commonly Mg2+)

(6) template DNA.

Varying any one of these components, or the cycling parameters including cycle number and annealing temperature,affects the specificity and/or yield of the PCR reaction.

PCR success heavily depends upon the individual template-primer combinations. Before beginning PCR, preliminary experiments to optimize reaction conditions are essential. Conditions for optimization may include variation of thecycling parameters and/or concentrations of essential reaction components. Additives (i.e. DMSO or betaine) are also useful when dealing with difficult templates such as GC rich sequences. For more information, see our PCR

Troubleshooting Tips on the web.

Pierce Nucleic Acid Technologies offers a variety of products featured within this application note. Table 1 summarizes these products.

3,References

R. A. Eeles and Stamps, A. C. Polymerase Chain Reaction (PCR) the Technique and its Applications. CRC Press, Austin, TX. 1993.R.G. Landes Company. Pages 4-25.

M.J. McPherson, B.D. Hames, and G.R. Taylor. (eds.) PCR 2: A Practical Approach. IRL Press, N.Y., New York. 1995. OxfordUniversity Press. Page 5.

A. Rolfs; Shculler, I.; Finckh, U.; and Weber-Rolfs, I. PCR: Clinical Diagnostics and Research. Springer-Verlag, Berlin Germany.1992. Springer-Verlag Berlin Heidelberg. Pages 51-60.

J. Sambrook and Russell, D. W. Molecular Cloning: A Laboratory Manual. Vol. 2. Third edition. Cold Spring Harbor Press, ColdSpring Harbor, New York. 2001 Cold Spring Harbor Press, Cold Spring Harbor, New York. Pages 8.1-8.126.